2-Pin Electric Window Lift Motor for Mazda 2 3 6 CX-7 CX-9 RX-8

PRODUCT OVERVIEW

This high-quality aftermarket electric window lift motor is designed for selected Mazda models and door positions, providing reliable operation and smooth window movement. Supplied as a single, brand new replacement unit.

KEY FEATURES

• Electric window lift motor
• 2-pin motor connector
• Suitable for specified front or rear door positions
• High-quality aftermarket construction
• Brand new replacement part
• MPN / Item No.: 100695MF
• Supplied as: 1 piece

SPECIFICATIONS

• Product type: Window lift motor
• Operating mode: Electric
• Connector type: 2-pin
• Placement on vehicle: Front or rear left, front or rear right (depending on model)
• Part type: High-quality aftermarket replacement
• Condition: Brand new
• Warranty: 12 months (part only)

VEHICLE COMPATIBILITY

Use this list as a guide only. Always compare the existing motor, plug type and part number where possible before purchase.

• Mazda 2 DY 12/2002–05/2007 (front right or rear right)
• Mazda 3 BK 09/2003–04/2009 (front left or rear right)
• Mazda 6 GG 05/2002–11/2007 (front left or rear right)
• Mazda CX-7 ER 09/2006–12/2012 (front left or rear right)
• Mazda CX-9 TB 11/2007–05/2016 (front left or rear right)
• Mazda RX-8 FE 07/2003–07/2012 (front right)

ANTI-PINCH FUNCTION SETUP

For motors with an anti-pinch function, correct setup is essential for safe operation.

• Do not test the motor before it is installed in the door, or the anti-pinch function may fail.
• Motors are pre-tested and set correctly prior to dispatch.
• Install the motor, connect it to the one-touch window switch and operate the switch to check full travel.
• If the window drops after reaching the top, perform the reset procedure below.

ANTI-PINCH RESET PROCEDURE

• Step 1: Pull the window switch briefly so the window moves slightly up to the top.
• Step 2: Hold the one-touch switch up for 3–5 seconds at the top position.
• Step 3: Press the window switch briefly so the window moves slightly down to the bottom.
• Step 4: Hold the one-touch switch down for 3–5 seconds at the bottom position.
• Step 5: Pull the one-touch switch again to move the window fully up.

The reset is complete if the window remains at the top. If it still drops, repeat the procedure until it holds correctly.

INSTALLATION & NOTES

• Professional installation by a qualified automotive technician is strongly recommended.
• Intended as a direct replacement component for repair purposes.
• Compare the product images, fixing points and connector style with your original motor before ordering.
• Actual product colour may vary slightly due to screen settings and lighting.